Master Vista Lacquer

Item number:

High-end solution for domestic areas

  • Good resistance
  • Low odour
  • Easy To apply
  • Indoor climate labelled

*The wood sample is shown on oak

5 L

Product details

  • Description
  • Specifications
  • Technical data sheet
  • Safety data sheet

VOC:

105 g/l, maximum VOC content (A/e (WB)): 130 g/l.

Density:

1.00-1.10 g/ml.

Shelf life:

2 years

Application Temperature:

+15-25°C and approx. 50% air humidity.

Coverage:

8-10 m²/L

Colours:

Colourless - Matt, Colourless - Silk-matt

Cleaning of tools:

Use water

Storage:

+10-25°C. Keep out of reach of children. Do not expose to heat (e.g. sunlight). Store frost-free during winter and cool during summer.

Packaging:

5 L

Viscosity:

20-25 Sec. DIN Cup 4

Between coats:

2-3 hours at 20°C

Light use:

4-6 hours at 20°C

Recommendation:

Wait 24 hours before putting furniture on the floor. Wait 5-7 days before covering with carpets and washing.If drying times are not followed, this can result in poor adhesion and reduced resistance. For each coat of lacquer, drying times will be increased. High temperature and low air humidity will reduce drying times. Low temperature and high air humidity will extend drying times.

Fully hard:

7 days at 20°C

Master Vista Lacquer is a clear, water-based lacquer with low odour. It dries to a durable surface with good resistance. The lacquer adds only very little colouration to the wood. It is the perfect choice for family homes, as it combines easy application with tough protection for all rooms.

Worksteps

Instructions
Products in use
It is important that both wood and lacquer have a temperature of min. 15°C (preferably around 20°C) and air humidity of approx. 50%. Make sure that the room is well-ventilated for optimal evaporation and drying time. For the final sanding to bare wood, use grit 100-120 sandpaper or sanding pad. Vacuum thoroughly and wipe the floor down afterwards, using a tightly-wrung water-soaked mop/cloth. Please note: WOCA Intensive Wood Cleaner can help to remove contaminates from fully sanded wooden floors before priming or lacquering. Please allow floor to fully dry overnight. The floor must be completely dry before priming or lacquering. When priming, use WOCA Master Base Primer for newly sanded wood to reduce side bonding. Alternatively, try WOCA Master Multi Primer for exotic wood species or old wood previously treated with oil or wax.

Always remember to test on a less visible spot to check the compatibility of the surface with the product.

  1. Primer and a coat of Master Vista Lacquer should be applied undiluted, using a brush or roller. Alternatively, two coats of lacquer can be applied. Leave the surface to dry until next day.
  2. Sand the surface with 100-120 and vacuum clean the surface thoroughly.
  3. Apply the final coat of undiluted Master Vista Lacquer.
Water and coloured fluids, such as red wine and coffee, must be wiped off immediately to prevent staining.